#15 Alesis io|26 repair & modding

So, i got my hands on one of these Alesis io|26 interfaces for pretty cheap (50 bucks delivered). "Of course", i bought it as faulty (can you see a pattern yet?), with the already "classic" issue of dead Firewire chip (the ubiquitous Texas Instruments TSB41AB2).

I went for it mainly for two reasons. First, because i knew it was based on the TC Applied Technologies Dice II chip, and as such, should have flexible enough mixing / routing options; second, due to the ADAT inputs available. The sort of "added bonus", one might say, were the gain adjustments for the 8 analog (mic/line) inputs.

#14 TC Electronic Studio Konnekt 48 "Dice II STD" replacement / transplant

A couple years ago i got my hands on a faulty one of these. Details of the revival process can be found over here; photos visible only for forum members though. Buuuuut since i'm in a good mood, OVER HERE you can find the link to a Google Drive folder with all the (relevant) photos i had posted on that particular thread - you're welcome...

The last issue i had to take care of, back then, was the (apparent?) shorting to ground that some of the I2S clock signal lines, coming out of the Dice II chip. Fortunately, it has several sets of these clock output signals in use, so between cutting a couple traces and adding some wire jumpers, i managed to put together and distribute a healthy set of clock signals to all the ADC & DAC chips that required them.

PS: It seems that the original link for the schematics of this unit is dead nowadays ("thank you", Music Group?), but for the sake of completeness and posterity, i've reuploaded it right over here.

#13 Fisher RS-1022 rehabilitation and bling-ification

So i had this old Fisher RS-1022 Studio Standard stereo receiver brought in, with one of the fuses in-line with the speaker outputs blown. Fair enough, that was easy enough to replace, they made it quite easy, with the fuseholders being mounted right on the rear panel. The clamps were nowhere near as elastic (or firm) as they might've once been, but with a pair of needle-nose pliers and a bit of creativity, that was no biggie.

Second issue, five of the six lamps that illuminate the tuning scale and the radio signal level were dead. In four of the dead ones, the fillament was attached only at one end, and in the fifth, it was attached at neither end. Interesting little lamps, 6.3v AC, 250mA, in a similar casing as 6x32mm glass fuses. Good luck finding replacement ones (which may very well just end up dying again anyway); these will get replaced with a few white LEDs recovered from a laptop display's backlight.