#18 Takstar / Gear4Music WPM-200 Wireless Monitor System part 2: receiver mods

Ok, turns out i lied in the previous post, as this part 2 won't be about the transmitter - so sue me...

Either way, into the meat of it: upon some listening tests with music, it turned out the expanders were misbehaving just awfully. They made the volume jump up and down virtually all the time, in a very disconcerting manner - basically briefly increasing the volume (noticeably) upon every louder bass note (and only for the duration), and dropping back down in between.

I took apart one of the receivers, and lifted the schematic of the expander chip and the associated passives around it. Pretty much exactly what's in the datasheet of the TA31101, with the exception of having omitted the coupling capacitor going to the "Comp In" (pin 11), thereby turning the compressor side of the chip into another 1:2-ratio expander, just like the other half.

#17 Takstar / Gear4Music WPM-200 Wireless Monitor System part 1: receiver teardown / li-po upgrade

This "part one" will be dealing only with the WPM-200 receivers and the lithium-upgrade pertaining to them. The transmitters and subsequent mods will be dealt with at a later date.

Fine, i'll admit, i miiiiiiiight be ever so slightly guilty of the whole "if all you have is a hammer, everything around you looks like a nail" thing, what with these nifty little one-cell charger & protection boards, but hey - at least it kinda validates(?) my "stockpiling" of laptop and phone batteries along the years. Now, i finally have the excuse to put some of them to good use and all that...

During my UK eBay browsing sessions a month or two (or seven?) back, i happened to come across a few listings of faulty wireless monitor sets (transmitter & bodypack-receiver) from this British music gear retailer. A bit of googling later, revealed to be straight rebadges of Takstar WPM-200 sets - nope, they hadn't even bothered changing the model number. The one thing they might've customized, though, are the radio frequency ranges / channels (since there are different regulations on different continents, and so on).

#15 Alesis io|26 repair & modding

So, i got my hands on one of these Alesis io|26 interfaces for pretty cheap (50 bucks delivered). "Of course", i bought it as faulty (can you see a pattern yet?), with the already "classic" issue of dead Firewire chip (the ubiquitous Texas Instruments TSB41AB2).

I went for it mainly for two reasons. First, because i knew it was based on the TC Applied Technologies Dice II chip, and as such, should have flexible enough mixing / routing options; second, due to the ADAT inputs available. The sort of "added bonus", one might say, were the gain adjustments for the 8 analog (mic/line) inputs.

#1 M-Audio Fast Track (mk1) gain and 18650 Li-Ion mod / upgrade

So i had this old, pre-"facelift" M-Audio Fast Track since 5-6 years ago, which had been lent to a bandmate for the last couple of years. A few weeks ago, i traded him up to a Scarlett 2i2, and i got my Fast Track back.

And then i got thinking - it has the convenient mono/stereo switch on the front (to have both inputs in mono, or input 1 on the left and 2 on the right), a headphone output, doesn't need a specific power supply (it being bus-powered)... 😏